Polyester Hydrolox® vs. Polyester OEM Hydro-entangled Media
Hydrolox® from Bondex P0F100HU1H |
Polyyester hydro0entangled bad from leading collector OEM |
||
---|---|---|---|
Fiber | 1.5d Polyester | 1.5d Polyester | |
Weight (oz/yd2) | 10 | 10 | |
Air Permeability (cfm) | 33.5 | 30.5 | |
Thickness (mil) | 51 | 50 | |
Mullens Burst (psi) | 400 | 405 | |
Tensile (MD lbf) | 213 | 213 | |
Tensile (CD lbf) | 323 | 270 | |
Elongation @ 11.24 lbf (%) | 0.9 | 2.1 | |
Heat Stability (% Shrinkage at 300 F) | 1.0 | 0.5 | |
VDI Test Data: (ASTM D6830-02) | |||
Average Cycle Time [s] | 185 | 174 | |
Total Efficiency % | 99.989 | 99.996 | |
Total Emissions % | 0.011 | 0.004 | |
Clean Gas Concentration [mg/m3] | 0.18 | 0.07 |
The property values listed in this specification are determined through statistical sampling from production campaigns and are subject to industry-wide tolerances. Typically, Bondex test protocol requires averaging at least ten representative measurements to produce a reported value, and the company reserves the right to make amendments without notice. Hydrolox® is a registered trademark of Bondex, Inc.